Custom M37/120 Medium Mechanical Seal For Chemical Pump

​

The selection of structural type of mechanical seals is an important step in selection, before selection, the following must be investigated:

1) working parameters: pressure p (MPa) , working temperature T (° C) , working speed V (m/s) , sealing shaft diameter d (mm) .

2) medium characteristics: concentration, viscosity, corrosion, solid particles and fiber impurities, whether easy to gasification or crystallization.

3) the operation of host working characteristics. Continuous or intermittent with the environmental conditions 4) the host of the allowable leakage of the seal, leakage direction (internal or external leakage-RRB- requirements, life and reliability requirements.

5) the main machine to the seal structure size limit.

Preperation:
1. Shaft Outside Diameter is within tolerance +-0.05mm
2. Shaft run out <0.1mm
3. Shaf end float <0.13mm
4, No sharp edges on the shaft over the o ring
Note:
During the installation,don't scratch or damage the o ring.lf anything is damaged,please contactwith Us to replace a new one.
Installation in strucstions:
1. The full set of cartridge seal is cleaned and exactly passed leakage examine before sale.Inorder to avoid damage,don't disassemble and clean the parts again before fixing.

2 The fitting allowance between the seal and shaft is dl h6 0.8,and there should be leading-inedge at the end of shaft.The outside diameter of shaft at the position of screw should be 01 0.2mm smaller,resisting the screw over-tighten.Lubricate the shaft with oil

3. Place the cartridge seal into the pump chamber,then:
A: Tighter four screw bolts of flanges,ensuring the medium leading in hole"G"at the top Position
B : Tighter four set screws and position the shaft sleeve on the shaft.
C: Remove four gauge plates.Please keep them and they wil be used in future installation and
disassemble.
D: Connect the medium lead_in pipe with hole"G"in order to flush away the friction heat and
flushing the seal chamber when pump running.
Note:
ter complete the installation,turning the shaft by hand to check for the rotationi he shat could not rotate smoothily,seal had been improperly installed.

We would like lo sincerely ooperale with Clients to supply high qually products and senice We beleve in establishing a long:erm cooperalive relalionshipis lhe key to suceess

M37 Medium Mechanical Seal

Custom Medium Mechanical Seal

M37 mech seal pump

Custom M37/120 Medium Mechanical Seal For Chemical Pump Images